I certainly know that i wont be using this type of cardboard again... Plus my intended slotting ideas didn't turn out the way i planned.. and if it wouldn't work with this mockup it certainly wont work for the X-board.
This turned out the way i wanted it to be, but the side slots might have to be cut more diagonally in order for this to work with the X-board. Nevertheless it is really sturdy, and i was considering reducing the side slots just in case they were unnecessary.
This one turned out the best compared to the rest. The weight distribution was good and it seemed pretty sturdy and strong. However this chair might take a lot of X-boards to produce... so i might have to reduce the side slices from 5 pieces to 3 pieces (or perhaps even 2 if it would be strong enough to hold somebody's weight). Might also increase the curvature of the base to add more rock to it.
No comments:
Post a Comment